GREAT PLANES S.E.5a 사용 설명서 - 페이지 14

{카테고리_이름} GREAT PLANES S.E.5a에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GREAT PLANES S.E.5a 20 페이지.

❏

10. Insert the two short cabanes in the forward slots and

the long cabanes in the aft slots as shown.

❏

11. Attach the top wing to the cabanes and the outer wing

struts with eight 2 x 8mm self-tapping washer head screws.

Once you have determined that the strut mounts are in the

correct location, use thin CA to glue them in the wing.

❏ ❏

12. Install a 100mm pushrod with the Z-bend at one

end in the control horn of the bottom wing aileron.

❏ ❏

13. Install the 100mm pushrod with the L-bend in the

control horn of the top wing's aileron. Secure it with a white

plastic retainer.

❏ ❏

14. Switch the radio system on. Make sure the ailerons are

centered. Tape the top wing aileron in the neutral position.

❏ ❏

15. Slide a 2.5 x 25mm piece of heat-shrink tubing over

both pushrods with both the top and bottom ailerons centered.

Shrink the heat-shrink tubing over the pushrods with a soldering

iron and apply a couple of drops of thin CA to the joint.

❏

16. Install the second set of pushrods between the other

set of ailerons.

FINISH THE MODEL

❏

1. Attach the main landing gear using two 2 x 9mm

machine screws and two 2mm flat washers. The landing

gear should be positioned so that it is leaning forward. Do

not fully tighten the screws.

❏

2. Attach the landing gear supports to the main landing gear

using two 2 x 5mm flat head screws. Do not tighten the screws.