GREAT PLANES Tori 사용 설명서 - 페이지 17
{카테고리_이름} GREAT PLANES Tori에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GREAT PLANES Tori 20 페이지.
페이지 인쇄
❏
2. Test-fi t the battery in place. Make sure it can be
installed so that the discharge and balance leads will not
contact the spinning motor.
❏
3. Optional: Make a battery strap from the included
hook-and-loop strap material. For typical fl ying, a battery
strap is not necessary. But if for some reason you have a
battery that does not conform well to the battery mount
plate, or if you plan on fl ying inverted or aggressively, you
may want to use the battery strap.
PREPARE THE MODEL FOR FLIGHT
Set the Control Throws
CAUTION: The propeller should not yet be installed.
If the propeller is installed on the motor, remove the
propeller while operating the radio to check the throws.
❏
1. Measure and set the control throws according to
the measurements provided below. If necessary, adjust
the throws with the programming in your transmitter and/
or adjusting where the pushrods connect to the servo
arms and/or control horns. NOTE: The control throws are
measured at the widest part of each control surface.
These are the recommended control surface throws:
HIGH RATE
Up
1/2"
ELEVATOR
[13mm]
25°
Right
1"
RUDDER
[25mm]
28°
Up
5/8"
AILERONS
[16mm]
33°
❏
2. OPTIONAL: Set up spoilerons. Spoilerons are up
defl ection of both ailerons to "spoil" lift causing the model
to sink. Spoilerons are not necessary, but can be an aid in
landing (to shorten the approach) or to get out of thermals
more quickly.
To program spoilerons in most radios, the aileron servos will
have to be connected to separate channels in the receiver.
Typically, the channels are mixed in the radio programming,
then another mix introduced to mix both aileron servos to
a switch, dial or slider for extending the spoilerons. Check
your radio to see if it has a dedicated spoiler function.
17
LOW RATE
Down
Up
Down
1/2"
5/16"
5/16"
[13mm]
[8mm]
[8mm]
25°
15°
Left
Right
1"
3/4"
3/4"
[25mm]
[19mm]
[19mm]
28°
20°
Down
Up
Down
3/8"
3/8"
1/4"
[10mm]
[10mm]
[6mm]
19°
19°
15°
Left
20°
13°