GREAT PLANES Spirit Select 사용 설명서 - 페이지 4

{카테고리_이름} GREAT PLANES Spirit Select에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GREAT PLANES Spirit Select 8 페이지. 2-meter sailplane

OPITIONAL SPOILERS

Note: Since the spoiler installation is optional, none of the

hardware has been included.

❏ ❏

1. Use a hobby knife to cut a hole in the bottom of the wing

sheeting for the spoiler tubing to exit the wing as shown.

❏ ❏

2. Pull the end of the spoiler tubing out of the wing just far

enough to glue it in place using thick CA.

❏ ❏

3. Cut the covering all around the edge of the spoiler and

remove it from the wing panel.

❏ ❏

4. Tape the spoiler in position in the wing using a strip of

cellophane or vinyl tape or a strip of covering. The tape should be

flexible enough to allow the spoiler to close on its own. The tape

should also be replaced occasionally as it will eventually rip.

❏ ❏

5. Thread a 42" [1070mm] length of braided fishing line (not

included) through the spoiler tubing in the wing.

❏ ❏

6. Thread one end of the line through the small hole in the

spoiler horn and use a piece of a round toothpick to hold the line in

the horn. Allow about 1/2" [13mm] to hang out the other side of the

horn for fine adjustments. It may be necessary to drill out the

spoiler control horn using a 3/32" [2.5mm] drill bit. Trim the shear

web to allow the toothpick to pass through without interference.

❏ ❏

7. Glue a small lead weight on the bottom side of the spoiler

to help it close. 1/4 – 1/2 oz. is usually enough since the airflow will

keep the spoilers closed when the plane is flying. Repeat steps 1

through 7 for the opposite spoiler.

❏

8. Mount the wing onto the fuselage and pull the ends of the

spoiler strings up to the spoiler servo. Position the spoiler servo

horn at the rearward end of its swing and wrap one spoiler string

around the screw in the horn. With the spoilers held closed, apply

a drop of CA to glue the string to itself, forming a small loop.

Remove that string and do the same steps to the other string. The

two strings should be the same length (be careful not to glue the

two strings together) and the spoilers should open and close

together. Adjustments can be made at the toothpick end if needed.