Automated Logic M4106nx 기술 지침 - 페이지 9
{카테고리_이름} Automated Logic M4106nx에 대한 기술 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Automated Logic M4106nx 10 페이지.
페이지 인쇄Table 5. Digital Output Channel Numbers
Channel
Point
Signal Type
Number
Digital
11
DO 1
HOA Status†
81
Digital
12
DO 2
HOA Status†
82
Digital
13
DO 3
HOA Status†
83
Digital
14
DO 4
HOA Status†
84
† Use digital input microblocks to
monitor the status of HOA Switches.
Table 6. Analog Output Channel Numbers
Channel
Point
Signal Type
Number
AO 1
Analog
41
AO 2
Analog
42
AO 3
Analog
43
AO 4
Analog
44
AO 5
Analog
45
AO 6
Analog
46
Transferring Memory
The M4106nx module can store up to 59
Function Blocks (FBs) and the MNM module
driver. If you have any problems transferring
memory to the module, contact Technical
Support at (770) 429-3002.
1. Log in to SuperVision on a workstation
connected to the CMnet. You can also
connect directly to the module using the
Access Port; see "Communicating with the
Workstation" on page 5.
2. Navigate to the module driver and look at
the module status page in SuperVision to
make sure the module type and number
agree with the module.
• To view the module status report in
SuperVision v3.0, click Tools -
Troubleshooting - Module Status.
• To view the module status report in
SuperVision v2.6b, press the Esc key,
type MO ,,module address,15 and
press Enter.
Revised 3/29/00 • M4106nx
Range
Offset
Gain
0 to 10VDC
0.00
0.0625
0 to 10VDC
0.00
0.0625
0 to 10VDC
0.00
0.0625
0 to 10VDC
0.00
0.0625
0 to 10VDC
0.00
0.0625
0 to 10VDC
0.00
0.0625
3. Transfer memory to the module.
• In SuperVision v3.0, click Tools -
Troubleshooting - Transfer Memory to
Module.
• In SuperVision v2.6b, download
memory for This Module.
4. When the memory transfer is finished,
check the module status report again.
Make sure the FB List shows all the FBs
you intended to transfer.
Troubleshooting
Formatting the Module
When you are unable to communicate with a
module, you can, as a last resort, manually
format the module to try to restore
communication. Formatting the module
erases all memory, so you need to transfer
memory back to the module once it is
formatted.
1. Turn the module's power off. Make sure
the module's address switches are not set
to '0 0'.
2. Press and hold the Format button (see
Figure 1 on page 2 for location).
3. While continuing to hold the Format
button, turn the module's power on.
4. Continue to hold the button until the Error
LED flashes three times in sync with the
Run LED.
5. Release the Format button.
6. Transfer memory to the module. Refer to
"Transferring Memory".
LEDs
The M4106nx module has several LED
indicators to show the status of certain
functions. Table 7 on page 10 explains the
Run and Error LED signals in detail to assist
troubleshooting.
9
© 2000 Automated Logic Corporation