Dynacord PowerSub 312 소유자 매뉴얼 - 페이지 15

{카테고리_이름} Dynacord PowerSub 312에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynacord PowerSub 312 20 페이지. Powered 3-channel subwoofer
Dynacord PowerSub 312에 대해서도 마찬가지입니다: 건축가 및 엔지니어 사양 (2 페이지)

페이지 인쇄

X-OVER

This switch allows changing the x-over frequency between subwoofer

and satellites. During normal operation this switch should be left at the

100Hz setting. Set the x-over switch to 140 Hz when using compact

satellite cabinets, e.g. VL62. For large-size cabinets, e.g. D12, set it to

70 Hz.

SUB LEVEL

This control sets the output volume of the PowerSub 312 in a range

between -dB and +10dB. The center position represents 0dB.

POWER switch

Mains switch for switching the unit's power ON or OFF. The mains switch lights after

switching on the PowerSub 312. In case the switch is not lit upon switching on the

power, make sure that the mains cord is connected correctly. If this is the case and

the PowerSub 312 still shows no function, please contact your local dealer.

MAINS IN

The mains connector is carried out as a PowerCon socket. A suitable 5m long

mains cord with PowerCon plug is supplied.

SPEAKER OUTPUTS

These outputs are for connecting the satellite

cabinets, e.g. Dynacord D8. Each output has an

output capacity of up to 250W into 4 ohms.

In other words, up to two loudspeaker systems with

8 ohms impedance can be connected in parallel per

output.

EXTERNAL SUB OUTPUT

This output allows connecting an additional passive

subwoofer, e.g. SUB 112. Maximum output capacity

is 400W into 8 ohms.

CONTROLS