HiB Vanquish 50 47600 빠른 시작 매뉴얼 - 페이지 2

{카테고리_이름} HiB Vanquish 50 47600에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HiB Vanquish 50 47600 4 페이지.

페이지 인쇄

Please Note

This product can only be recessed fitted into a wall. Before installing ensure you take note of

measurements of the recessed area and the side fixing points inside the cabinet carcass (See fig. A & D).

You may need to remove the door / doors to make it easier to fit. This can be done by un-clipping the

hinges. (There is a release catch at the back of the hinge). DO NOT FIT SHELVES AT THIS STAGE.

Electrical Safety Information

HiB recommends that all electrical bathroom

products should only be fitted by a suitably

qualified, Part P registered electrician in

accordance with current IEE regulations.

Ensure mains power supply is switched off

before starting installation. Before drilling, ensure

there are no hidden cables or pipes in the wall.

Fixing Preparation

Before installation, ensure the construction of

the partition wall is suitable to accommodate for

the size and weight of a recessed cabinet.

The cabinet should be placed in a suitable

location, (according to the zonal diagram (Fig. 1)

on the back page).

Ensure the domestic electrical mains supply to

which the cabinet is being connected is turned

off.

Measure the dimension of the cabinet

carcass (but not the front aluminium fascia).

Using these dimensions, take a soft pencil

and mark the outline for the required

aperture in the wall. Take great care to

mark this accurately, straight and level.

Using an appropriate tool, cut or channel

out the aperture in the wall where the

cabinet will fit (Fig. A).

If it is necessary, install supporting baton(s)

or noggin(s) around the recessed area (see

Fig. B) to which the cabinet can be secured.

These supports must be completely vertical

and parallel to the cabinet to prevent the

cabinet twisting when fitted.

Connect the domestic mains supply

according to the wiring diagram (See Fig.

2) on the back page and manoeuvre the

cabinet into the wall aperture (See Fig. C).

Using a suitable screwdriver or drill, secure

the cabinet into the wall aperture, via two

holes with the supplied screws (two on

each side) See Fig. D.

Insert metal shelf supports in desired

position. Put glass shelf into shelf supports

and tighten the plastic grub screw whilst

holding the metal support. This will

securely clamp the shelf into position see

Fig.E.

If necessary, hinges can be adjusted to

reposition the door(s) see Fig.F.

Switch mains supply back on.

Operation Instructions

This cabinet is fitted with colour temperature

changing technology.

To turn illumination on, touch the sensor once.

To change the colour temperature, touch and

hold the sensor until desired colour is obtained.

The colour temp is then set until changed again.

Heated Pad is only on when mirror is illuminated.

Care Instructions

Do not use abrasives or solvents when cleaning

this product.

Wipe off all water spillages as soon as possible

using a soft, damp cloth.

Aftercare Service

In the unlikely event that this product should fail

please contact HiB customer services, contact

detail shown on the back page.

Charging Socket(s)

Charger socket(s) are suitable for charging

and powering electric razors, trimmers and

toothbrushes. Some cabinets may contain

multiple charging sockets.

NB. On first use of the charger socket, inserting the

plug may prove to be stiff. Reasonable force may

be required to fully insert the plug. Make sure that

the cabinet is held firmly so that it is not pushed off

the wall. After a few uses, stiffness will ease and the

socket will function as normal.