Automated Pet Care Products LITTER-ROBOT 매뉴얼 - 페이지 10

{카테고리_이름} Automated Pet Care Products LITTER-ROBOT에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Automated Pet Care Products LITTER-ROBOT 16 페이지. Self-cleaning litter box
Automated Pet Care Products LITTER-ROBOT에 대해서도 마찬가지입니다: 매뉴얼 (18 페이지), 사용자 설명서 (19 페이지)

페이지 인쇄

Automated Pet Care Products, Inc.

Adjusting the Cat Sensor

Adjusting the cat sensor is quite easy. You will need a

pair of pliers or a small wrench.

1. Unplug the power cord. Remove the waste

drawer by pulling it out.

2. Locate the sensor at the front and in the center

of the bottom of the base. You will see two

wires and a lock nut.

3. Remove the nut using a pliers or wrench,

holding the loose wire in place as you remove

the nut.

4. Remove the wire that was held in place by the

nut.

5. The next visible item on top looks like a washer.

If you press down on the base, you will see that

it is actually a threaded cylinder with an

extended lip at the top. The cat sensor

sensitivity is adjusted by turning this "T-nut".

40 W. Howard, Suite B-5, Pontiac, MI 48342

Toll Free: 877-250-7729 Fax: 248-253-1797

www.Litter-Robot.com

Automated Pet Care Products, Inc.

INCREASE SENSITIVITY

(If the cat is not triggering the Litter-Robot to cycle):

Turn the T-nut one turn counter clockwise.

DECREASE SENSITIVITY

(If the green light won't come on)

Turn the T-nut one turn clockwise. This will tighten the

spring and make the sensor less sensitive.

Now, you need to put it back together:

Put the loose wire harness back on, centering it over the

bolt as best you can. Replace the nut (flat side down)

and hand tighten. Hold the wire again while you finish

tightening the nut.

You may have to adjust the sensitivity a few times until

you "tweak" it just right to the specific setting that

works for your cat.

If you need any assistance, call Customer Service toll-

free at 1-877-250-7729.

40 W. Howard, Suite B-5, Pontiac, MI 48342

Toll Free: 877-250-7729 Fax: 248-253-1797