Automated Pet Care Products LITTER-ROBOT 사용자 설명서 - 페이지 9
{카테고리_이름} Automated Pet Care Products LITTER-ROBOT에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Automated Pet Care Products LITTER-ROBOT 19 페이지. Self-cleaning litter box
Automated Pet Care Products LITTER-ROBOT에 대해서도 마찬가지입니다: 매뉴얼 (16 페이지), 매뉴얼 (18 페이지)
페이지 인쇄After pouring litter in the Globe through the waste
ports, pressing any button on the Control Panel will
return the Globe to the home position.
Next, grab the handle of the Internal Guard and
rotate it downward (counter-clockwise). This closes
the Internal Guard. The square waste ports are
now covered by the Internal Guard.
When the Globe is in the home position, the litter
bed should be level and not higher than about 2
inches below the bottom rim of the cat entrance
opening.
5.
If this is the first time you filled the Litter-Robot and
are trying to get your cats acclimated, you can pour
a cup of used litter from the old litter box on top of
the new litter in the Litter-Robot. This will provide
a familiar scent for your cat. See the section
"Getting Your Cat to Use the Litter-Robot" for more
tips.
NOTE
During the first few days of operation the plastic Globe
may exhibit a high degree of static charge. Litter will
cling to all interior surfaces of the Globe. Clinging litter
will eventually be released, but not necessarily at an
ideal moment causing some granules to bounce out
through the waste ports or the entrance opening during
the clean cycle. The static cling should subside within a
few cycles.
40 W. Howard, Suite B-5, Pontiac, MI 48342
Toll Free: 877-250-7729 Fax: 248-253-1797
www.Litter-Robot.com
14
How the Cat Sensor Works
The Litter-Robot Cat Sensor is a weight sensitive switch
that detects your cat entering or exiting the Globe.
Your cat must be at least five (5) lbs for the
sensor to work. Do not use the Litter-Robot with
kittens or cats that weigh less than five lbs.
Always be sure that each cat in your household is
heavy enough to activate the Cat Sensor before
you let the Litter-Robot operate in automatic
mode.
Make sure the Litter-Robot is placed on a level
firm surface. Placing the Litter-Robot on deep
carpet may require adjusting the cat sensor
(more sensitive).
A seven minute count-down is started when the cat
leaves the Globe. At the end of the count-down the
Litter-Robot will start its cleaning cycle. Any subsequent
tripping of the Cat Sensor starts a new seven minute
count-down, preventing the Globe from rotating with
your cat inside.
Caution:
Please make sure that your smallest cat weighs at
least 5 lbs before operating the Litter-Robot in
the unattended automatic mode. Your cat must
weigh at least 5 lbs to trip the Cat Sensor.
15
40 W. Howard, Suite B-5, Pontiac, MI 48342
Toll Free: 877-250-7729 Fax: 248-253-1797
www.Litter-Robot.com