Emergency Caller Products XP-4-300 사용자 설명서
{카테고리_이름} Emergency Caller Products XP-4-300에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Emergency Caller Products XP-4-300 2 페이지. Transmitter sensor pad
페이지 인쇄Changing
Batteries:
1) Remove
4 screws from the back of the housing
2)
Make sure thal the batteries is inserted with the oositive
(+) terminal
facing up 3)After replacing
the batleries,
make sure housing is properly secured.
The batteries
should be replaced
every year or as needed with
your transmitting
unit:To replace the batteries
in
your transmitter
you will need two 3-volt Lithium
batteries
(CR2025
or equivalent).
Carefully
remove lhe screws on the transmitter
case and separate
lhe transmitter
housing.
Remove
the old batteries
lrom the battery clip and
place the new batteries
under the clip with the pos-
itive ends of both batteries
facing up.
Small, CompactSize
- Batteries
Included
Water resistant
for shower,
bath, rain, etc.
0n-0ff switch.
Complete
wilh accessories.
AUT0MATICALLY
activates when sensing loss
of pressure
from sensor pad!
No buttons
to press or cords to pull.
Operates
with any of the
Emergency
Caller Products
below
EC-1 ----- Enunciator-----
Fall Systems(Not
Shown)
1'
$ndt(
nrurunE
i'EI
xP-4-300
Transmitter
Sensor Pad
USER MANUAL
QUICK START GUIDE
[meryency Caller Products (I) 800-227-2474 lJl 800-762-7613
www.enrergencycaller.corn
sllesittenrergencycaller.con
LI.S.A.
and world Patents
lssued
and Pendlng
on Grtaln Products
,{ffin1',.
xP-4-300
transmitter
sensor pad
should be tested at least
once per week
te
b r '
f f i ' ;
H'p.
t
f