Emergency Caller Products XP-5-300 사용자 설명서
{카테고리_이름} Emergency Caller Products XP-5-300에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Emergency Caller Products XP-5-300 2 페이지. Transmitter sensor pad
페이지 인쇄@
IITJ!
N
Changing Batteries:
1 ) Remove 4 screws from the back of the housing 2)
Make sure that the batteries is inserted with the Dositive
(+) terminal facing up 3) Afier replacing the batteries,
make sure housing is properly secured. The tsatteries
should be replaced every year or as needed with
your transmitting unit:To replace the batteries in
your transmitter you will need two 3-volt Lithium
batteries (CR2025 or equivalent).
Carefully remove the screv\is on the transmitter
case and separate the transmitter housing.
Remove the old batteries from the battery dip and
place the new batteries under the dip with the pos-
itive ends of both batteries facing up.
Small, Compact Size - Batteries Included
Water resistant for shov'/er, bath, rain, etc.
On-Off switch.
Complete with accessories.
AUTOMATICALLY activates when sensing loss
of pressure from sensor pad!
No buttons to press or cords to pull.
Operates with any of the
Emergency Caller Products below
EC-1 ---- Enunciator -.-* Fall Systems(Not Shown)
{ * '
i
ulrci
i
nfi|ri
i * ' - i
' I
, 1
I
rr+'
XP-S300
Batteries
Transmitter sensor
pad should be tested at least
once per week.
xP-5-300
Transmitter Sensor Pad
(Size: 24"x30"1
USER MANUAL
QUICK START GUIDE
Erncrgerrcy Cafler Produ(ts $l A(n-227 -2474 (J, 8OO-762-761t
www.emergemcycaller.conr
uS.A. arrt wodd Patents lsued md Fendlng 6 Certaln ttodKts
ffahnv:'
)
)*