Great Wall V200 매뉴얼 - 페이지 12

{카테고리_이름} Great Wall V200에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Great Wall V200 19 페이지. Keyless entry and immobilizer

SA220 (Sailor) Programming Method "B"

Procedure B

1. Remove the LHF kick panel to gain access to the Central Locking controller.

2. Ensure all the doors are in an unlocked state.

3. Refer to the diagram below and earth out pin 9 of the controller.

4. Insert the ignition key into the ignition and turn the key from Off to On 4 to 6 times

within 25 seconds finishing on the ON position.

5. At this point the doors will lock and unlock once to indicate that the programming

mode has been entered.

6. Press the Lock button on all the remotes one at a time to lean the remotes. After

each press of the Lock button the doors will lock and unlock once to indicate that

the key has been learned.

7. Remove the earth wire and refit the module and trim.