Celec ES-65 설치 매뉴얼 - 페이지 8

{카테고리_이름} Celec ES-65에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Celec ES-65 10 페이지.

Use this instruction

If 125 Amp circuit breaker is unavailable and require a new disconnect switch or

other approved device.

ES-65 unit is designed for use with Customer Main Breaker Panel Three Phase

277/480V AC WYE/Delta Connection, up to 1000 Ampere.

Representative must purchase 125 Amp Blade-Fused Disconnect Switch or

125 Amp Circuit Breaker for connection of ES-65 to Customer Main Breaker Panel.

1. Install new 125 Amp Blade-Fused disconnect or External Circuit Breaker switch to wall or existing

backboard. Qualified Representative should note if codes allow for direct connection to bus bars in

main breaker panel or requires installation of an additional sub panel.

2. Wire in rigid conduit between customer main breaker panel & external disconnect switch. Connect

usi g /

to ES-

3. Locate earth ground connection in ES-65 and connect to grounding bar or to earth ground rod in

main breaker panel.

4. For rest of connection follow the Connection type#1 on page 5.

________________________________________________________________________________________

Field Installation Manual

Connection Type#3

o duit.

ES-65