HIBLOW HP Series 매뉴얼 - 페이지 8

{카테고리_이름} HIBLOW HP Series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HIBLOW HP Series 8 페이지.
HIBLOW HP Series에 대해서도 마찬가지입니다: 매뉴얼 (5 페이지), 매뉴얼 (9 페이지), 빠른 시작 매뉴얼 (7 페이지)

페이지 인쇄

HP- 150 / 200

STEP

MOUNTING THE ELECTROMAGNET

Mount new electromagnet in the unit.

Fix frame stay temporarily.

(Do not tighten screw of frame stay and keep

them rather loose.)

Tighten up hexagonal nuts with nut driver.

Fasten screws of frame stay.

STEP

Install the SP switch to the frame with the screws.

●Be careful of the direction of switch lever. (Refer to the

pictures)

STEP

Insert the wire into the silicon tube, and tie up in a

bundle.

Strip the coating off each wire.

(5-7mm from the end)

Connect the wires to the terminals.

Solder the wires to the terminals.

The wire requires a soldered connection.

STEP

This completes the electromagnet replacement

procedure.

REPLACING THE ELECTROMAGNET