HIBLOW HP Series 빠른 시작 매뉴얼 - 페이지 7

{카테고리_이름} HIBLOW HP Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HIBLOW HP Series 7 페이지.
HIBLOW HP Series에 대해서도 마찬가지입니다: 매뉴얼 (5 페이지), 매뉴얼 (8 페이지), 매뉴얼 (9 페이지)

페이지 인쇄

HP- 60/80

STEP

MOUNTING THE ELECTROMAGNET

Mount new electromagnet in the unit.

Tighten up hexagonal nuts with nut driver.

STEP

Install the SP switch to the frame with the screws.

●Be careful of the direction of switch lever. (Refer to the

pictures)

STEP

Insert the wire into the silicon tube, and tie up in a

bundle.

Strip the coating off each wire.

(5-7mm from the end)

Connect the wires to the terminals.

Solder the wires to the terminals.

The wire requires a soldered connection.

STEP

This completes the electromagnet replacement

procedure.

PO Box 1524, Oxenford QLD 4210  35 Scenic Cr, Coomera QLD 4209

Email: [email protected]  Web: www.goodies.net.au

REPLACING THE ELECTROMAGNET

Goodies Wastewater Supplies

Phone: 1300 282 181  Fax: 1300 282 989