HIBLOW HP-50 매뉴얼 - 페이지 3

{카테고리_이름} HIBLOW HP-50에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HIBLOW HP-50 5 페이지.

HP- 30/40/50

STEP

FITTING CHAMBER BLOCKS

Fit the actuating rod by aligning it with the groove

and tighten U-lock nut and flat washer by the nut

driver.

●Use new U-lock nut and washer, otherwise, U-lock nut

may work loose and cause malfunction.

STEP

Insert the actuating rod into the machine body. Be

sure to fit the positioning boss on the diaphragm

base into the concave part of the frame stay.

Secure the diaphragm mounting block on the

other side and tighten washers and U-lock nuts

with the nut driver.

Make sure that gap between the actuating rod

and the electromagnets is even.

STEP

Mount the casing block with screws (4screws on

each side).

And insert L-tube into the nozzle of casing block.

Complete the other casing block at the same way.

STEP

Install the sound absorber. (HP-50)

●Be extremely careful not to pinch the Sound Absorber

in the Upper Housing.

Place the upper housing back on body.

Fasten it with the bolts.

Then, place the filter and filter cover on the upper

FILTER CLEANING AND

housing. (Refer to

REPLACEMENT

)

REPLACING THE CHAMBER BLOCK