Daytona DS300LR 사용 설명서 및 안전 지침 - 페이지 6

{카테고리_이름} Daytona DS300LR에 대한 사용 설명서 및 안전 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Daytona DS300LR 13 페이지. 3 ton heavy duty low profile long reach floor jac

페이지 인쇄

Set Up

Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this

manual including all text under subheadings therein before set up or use of this product.

Removing Shipping Block

CAUTION! The Handle Socket will be held down by a plastic block under tension. Wear Ansi-

approved safety goggles before freeing Handle Socket. Hold Handle Socket down while

removing block. After removal, carefully swing Handle Socket up until tension is released.

Attaching the Handle

1. Slide the Upper Handle into the Lower Handle.

Line the Button on the Lower Handle up with the

hole in the Upper Handle until it clicks into place.

Bleeding Trapped Air

1. With the Jack fully lowered, remove both Screws

on the end of the Cover Plate that is closer to the

Saddle. Swing Cover Plate open. See Figure A.

2. Remove the Fill Plug on top of the Cylinder.

Check that the oil level inside the Cylinder just

covers the top of the Piston. See Figure B.

3. Turn the Handle counterclockwise to open the valve.

4. Pump the Handle up and down quickly

10-15 times to force air from the system.

5. Replace the Fill Plug, close the

Cover Plate, and reinstall the Screws.

Adding Oil

NOTICE: To prevent damage and premature wear,

use only non-detergent 22 weight hydraulic jack oil.

1. With the Jack fully lowered, remove both Screws

on the end of the Cover Plate that is closer to

the Saddle. Swing the Cover Plate open.

2. Remove the Fill Plug on top of the Cylinder.

3. Add non-detergent 22 weight hydraulic jack oil

into the Fill Plug hole slowly until the oil level just

covers the top of the Piston inside the Cylinder.

4. Replace the Fill Plug, close the

Cover Plate, and reinstall the Screws.

Page 6

For technical questions, please call 1-888-866-5797.

2. Loosen the Handle Release Bolt and insert the

grooved end of the Handle into the Handle Socket.

3. Tighten the Handle Release Bolt. Gently pull up

on the Handle to make sure that it is secure.

Fill Plug

Figure A: Hydraulic Unit

Fill Plug

Oil

Piston

Cylinder

Figure B: Fill Level

Safety Valve Covers

Do not open or adjust.

fill level

Floor Jack