HIBLOW HP Series 매뉴얼 - 페이지 7

{카테고리_이름} HIBLOW HP Series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HIBLOW HP Series 8 페이지.
HIBLOW HP Series에 대해서도 마찬가지입니다: 매뉴얼 (5 페이지), 매뉴얼 (9 페이지), 빠른 시작 매뉴얼 (7 페이지)

페이지 인쇄

HP- 150 / 200

CAUTION

！

●Be sure to unplug the pump unit.

●When performing replacement work, the pump body may still be hot and you could

get burned. So please wait until the pump has cooled before handling.

●Be sure to remove the chamber block and the actuating rod before replacing the

electromagnet.

●It is better to let an experienced technician handle the soldering process.

Take precautions against getting burned.

STEP

REMOVAL OF ELECTROMAGNET

Cut the wire from the terminals on electromagnets

with nippers.

●It is recommended that you make a note of the wiring.

STEP

Loosen the screw, fixing SP switch and remove it .

(There are hexagonal nuts at SP switch side. Be

sure not to lose them as they fall inside the unit.)

STEP

Remove the hexagonal nuts by the nut driver.

(8mm wrench)

Loosen the screw holding the frame stay, and

remove it.

Pull out the electromagnet from the pump body.

REPLACING THE ELECTROMAGNET