Celectron Audio WD15A 사용자 설명서 - 페이지 11

{카테고리_이름} Celectron Audio WD15A에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Celectron Audio WD15A 12 페이지. Active floor monitors

RED LED illuminates when the internal amplifier's output is limited.

NOTE: When this LED flashes reduce the input signal level.

6. PRESET MONITOR/FOH selector

This switch allows the selection between two equalisation settings, suited to two different uses.

MONITOR

Suited for stage monitoring sound reinforcement for an improved feedback rejection.

FOH

This preset has been designed for typical sound reinforcement applications with the speaker mounted on floor

stand.

7. POWER switch

Speaker is "ON" when the switch is in the "I" position. .

NOTE: When you shut down your equipment, turn off the speaker first. When powering up, turn on the speaker last.

8. ON indicator

GREEN LED: when lighted indicates that the amplifier has been turned on and AC power is available.

9. LINE VOLTAGE selector

This switch sets the AC voltage line of your country (usually it is set by factory and isn't necessary to change it).

The 115V setting is for mains line in the range of 105-120V~ and 230V setting is for mains line in the range of

210-240V~.

WARNING: an incorrect setting of AC LINE VOLTAGE could damage seriously the internal electronics!

10. AC~ socket

Here's where you plug in your speaker's mains supply cord. You should always use the mains cord supplied with the

speaker. Be sure your speaker is turned off before you plug in the cord. .

11. FUSE holder

Here is where the mains protection fuse is placed.

REPLACE THE PROTECTION FUSE ONLY WITH SAME TYPE AS SHOWN ON THE PRODUCT.

IF AFTER THE SUBSTITUTION, THE FUSE INTERRUPTS AGAIN THE APPARATUS WORKING, DO NOT TRY AGAIN THEN

CONTACT THE CELECTRON SERVICE CENTER.