GreatCo GBI-34 주택 소유자 설치 지침 및 운영 매뉴얼 - 페이지 11
{카테고리_이름} GreatCo GBI-34에 대한 주택 소유자 설치 지침 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. GreatCo GBI-34 11 페이지. Gallery electric fireplaces
GreatCo GBI-34에 대해서도 마찬가지입니다: 주택 소유자 설치 지침 및 운영 매뉴얼 (11 페이지), 주택 소유자 설치 지침 및 운영 매뉴얼 (10 페이지)
페이지 인쇄Problem
Fireplace not responding to
remote commands
Fireplace trips circuit breaker
or blows fuse when turned on
Heater is excessively noisy
Odor coming from
heater/blower
Flame effect frozen or
stuttering
Heater not outputting heat
when turned on.
LED Lighting not turning on
TROUBLESHOOTING
Possible Causes
Switch on fireplace not in the ON
position
Remote control battery dead or
not inserted properly
Remote is not in range of fireplace
or not aimed correctly
Improper circuit rating
Too many appliances plugged into
the same circuit
Blower assembly is dirty
Defective blower
Normal operation
Defective heater
Defective flame motor
Thermal switch tripped
Heater is defective
Thermostat is cycled off
Lighting may be defective
14400 Southcross Drive West • Suite 100 • Burnsville, MN 55306
Toll Free: 1-866-303-4028 •
Switch must be in the ON position for
remote operation
Insert or check battery for correct
orientation
Move closer to fireplace and aim remote
directly at it.
Ensure unit is plugged into a dedicated
15 amp circuit
Unplug other appliances on the same
circuit
Unplug unit and clean blower
Blower replacement or repair necessary
Heater is burning off dust accumulated
during manufacture or non-use periods.
This should only be noticeable for a brief
period after turning on.
Heater may require replacement or
repair
Flame motor repair or replacement
required.
Turn off unit and unplug for 5 minutes.
This is a safety feature to prevent
overheating
Replacement or repair may be required
Set thermostat to higher setting
Repair or replacement may be required.
10
Solution