GreatCo GE-50 설치 지침 및 운영 매뉴얼 - 페이지 8

{카테고리_이름} GreatCo GE-50에 대한 설치 지침 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. GreatCo GE-50 9 페이지. Gallery electric fireplaces

REMOTE CONTROL FUNCTIONS

This appliance can be operated by both remote control and manual buttons located on the side of the fire box. Once the

unit has been properly connected to a grounded electrical outlet, turn on the main power switch located on the right-hand

side of the appliance. A beep should be heard when the power is first switched on.

CAUTION ! The unit's power cord must be connected to a properly grounded and protected 120V outlet.

WARNING! Do not operate the unit if it is damaged or has malfunctioned. If you suspect the unit is damaged,

NOTE! To use both remote and manual function the main power switch must be in "ON" position.

● Operating by Remote Handset



Make sure the battery are installed properly in the remote control.



The effective range of the remote control is up to 4 meters or 13 feet.

ICON

90236 GE50-94 REV A 8-3-12

OPERATING INSTRUCTIONS:

Always use ground fault protection where required by the electrical code.

please call a qualified service technician to inspect and to replace any part of the electrical system

If necessary.

TITLE

POWER

FLAME

HEATER

TEMP

TIMER

BACK LIGHT

● Operating by Manual Button

MANUAL ON/OFF SWITCH

This switch turns heater on/off, and permits / prohibits use of remote

and panel push buttons.

FLAME BUTTON

The fire has four flame effects, by pressing the flame effect button the

unit will cycle through each effect.

HEATER BUTTON

Press once turns 750W power on. (Pilot lights illuminated ●○)

Press again turns 1500W power on (Pilot lights illuminated ●●)

Press third time turns heater off. (Pilot lights illuminated ○○)

Press once turns appliance on. Press again turns appliance off.

The fire has four flame effects, by pressing the flame effect button the

unit will cycle through each effect.

Press once turns 750W power on. (Pilot lights illuminated ●○)

Press again turns 1500W power on (Pilot lights illuminated ●●)

Press third time turns heater off. (Pilot lights illuminated ○○)

Digital display shows the TEMP setting 23°C (73°F) (default), with 14

settings circle from "OFF", "16°C" to "28°C" (61°F to 82°F).

The TEMP will increase by 1°C/F up to 28°C(82°F) when pressed

each time.

By pressing the TEMP for 3S, the digital display can switch

between °C and °F.

Cycles from OFF, 0.5H, 1H, 2H, 3H, 4H, 5H, 6H, 7H, 8H, to 9H.

By pressing the backlight button the unit will cycle through 12 Colors,

a color-cycle mode, and OFF setting.

FUNCTION