GreatCo GE-70 설치 지침 및 운영 매뉴얼 - 페이지 7

{카테고리_이름} GreatCo GE-70에 대한 설치 지침 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. GreatCo GE-70 9 페이지. Gallery electric fireplaces

A 15 AMP, 120 Volt, 60 Hz circuit with a properly grounded outlet is required. The unit comes standard with 6 feet (1.8 m)

three wire cord, exiting from the rear of the fireplace. Plan the installation to avoid the use of an extension cord. Preferably,

the fireplace will be on a dedicated circuit as other appliances on the same circuit may cause the circuit breaker to trip or

the fuse to blow when the heater is in operation.

Clean the glass trim using a soft cloth and household glass cleaner and buff with a clean soft cloth if streaking occurs.

WARNING: ALWAYS UNPLUG THE CORD BEFORE MOVING OR SERVICING.

DO NOT IMMERSE HEATER IN WATER!



Always turn OFF the heater and disconnect the cord from the electrical outlet before cleaning your heater.



Light accumulated dust may be removed from the heater with a soft cloth or vacuum cleaner.



Wipe the exterior surfaces of the heater occasionally with a slightly damp cloth (not dripping wet) using a solution

of mild detergent and water. Dry the case thoroughly before operating the heater.

Caution: Do not allow water to run into the interior of the heater as this could create a fire or electric shock hazard.



The fan motor is factory lubricated for life and will not require further lubrication.

Warning: Any other servicing needed must be performed by an authorized service representative. Do not attempt to

ELECTRICAL CONNECTION