AirCube AC-12HYDROKIT-60G 사용 설명서 - 페이지 5

{카테고리_이름} AirCube AC-12HYDROKIT-60G에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AirCube AC-12HYDROKIT-60G 8 페이지. Active oxigen grow system

SETTING UP THE GROW SYSTEM

Step 1: Set up Reservoir

Place the Brain Controller in front of the reservoir with

a timer facing away from the reservoir.

Measure and cut tubing to reach from the top of the

Brain Controller to the bottom of the inside of the

reservoir.

Assign a water pump as "Fill Pump", and place it at

the bottom of the reservoir. Connect one end of the

tubing to the Fill Pump.

Use the Tubing Puncture Tool to make a small hole in

the tubing inside of the reservoir near the top. Insert

the Vacuum

Break Barbed Elbow into the hole with the valve

facing downward to prevent water from siphoning.

Plug the Fill Pump into the outlet on the side of the

Brain Controller labeled "Fill Pump."

Step 2: Set up Brain Controller

There are 2 upper water level float valves that are on

an adjustable mount so the Brain Controller can be

used with different size pots. Adjust float valves to

preferred level. Ensure that the float valve does not

exceed the height of the top of any buckets.

Insert grommets into the 6 holes on the bottom of the

Brain Controller.

Insert 2 straight connectors into the front 2 grommets

on the bottom of the Brain Controller. Make sure

they are inserted all the way into the grommet. Insert

4 Stoppers into the rear 4 grommets. These can be

removed to add additional buckets.

Insert grommets into the holes on the Brain Controller

lid.

Insert straight connectors into the grommets on the

Brain Controller lid. [Change to insert connectors in

both holes]