Automatic Solutions 750L I Range 설치 및 유지 관리 매뉴얼 - 페이지 11

{카테고리_이름} Automatic Solutions 750L I Range에 대한 설치 및 유지 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Automatic Solutions 750L I Range 16 페이지. Sliding gate operators

페이지 인쇄

1. Electrical Connections

Commissioning

Position the gate halfway and tighten knurled knob at back of slider, very firmly, by hand so gate will

drive.

Power up board and with gate in the half way position, press transmitter or manual control switch so

operator drives gate.

The first pulse will always open gate, green LED will flash (top right hand corner) if it does not, then

reverse 2 of the motor wires.

Check which limit switch stops gate in each direction and adjust cams so gate will stop in the fully

open and closed positions.

Limit switches should not switch off the gates too soon (before reaching the stops) and conversely not

too late, so the torque limiter is operating.

Tighten torque limiter knurled knob.

Set open & closed travel time.

Check that all safety devices work as designed and the electromagnetic lock holds the gate firmly

closed (if fitted).

Install cover using screws provided in the front and sides to hold cover firm.

Provide full details to the owner concerning the operation and relevant maintenance and disconnect

details.

4. M

ANUAL

ELEASE

Should the power fail or for some other reason the gate does not operate in the normal motorised

manner, manual disconnection can be achieved by:-

Turn power off to the control box and isolate.

By using the key, unlock the door on the back of the cover.

Turn the large knob anticlockwise which will release the drive

Manually slide open the gate.

NSTRUCTIONS