Automatic Solutions ASA 550L I 설치 및 유지 관리 매뉴얼 - 페이지 5
{카테고리_이름} Automatic Solutions ASA 550L I에 대한 설치 및 유지 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Automatic Solutions ASA 550L I 16 페이지. Sliding gate operators
1. S
P
AFETY
RECAUTIONS
WARNING!
FAILURE TO FOLLO
INSTRUCTIONS COULD RESULT IN
.
AND EQUIPMENT
Appropriately licensed and competen
The operators are designed specifica
for any other purpose.
Before commencing installation, read
Check that the operator and controls
Check the gate or door and its associ
compression and other various traps
the general installation and surround
Check the gateposts or mounting str
operator and the load of the opening
CAUTION!
Always incorporate the appropria
devices to protect both equipment
operator in auto close mode.
Display any necessary signs to indica
The operators are not designed to be u
All electrical connections and wiring
(Or its counterpart for other countries
WARNING! ELECTRICITY CAN KILL
The manufacturer of the automation
to either the operator, gate or door an
o Wrong or poor installation p
o No or inadequate safety dev
o Either the surrounding struct
the task in hand.
o Inefficient locking devices w
o Poor maintenance on the eq
o Any other circumstances be
Isolate power before attempting any
Only original spare parts are to be u
Keep loose clothing and hands clear
The installer should provide all info
instructions regarding the manual ov
LOW THESE SAFETY PRECAUTIONS AND INS
IN INJURY OR DEATH AND
etent personnel only should install the automation equ
ically to open and close sliding gates or doors and sh
, read through this installation manual.
ols are in new condition and have not been damaged i
ociated support posts and walls to protect against shea
aps which could cause serious injury or death. Take in
nding environment.
structure has the necessary strength and rigidity to su
ng and closing gate motion.
riate Photo Electric Cells, Induction Loops and an
ent and personnel. Extra caution should be employ
dicate any danger areas and automatic operation of th
be used in any hazardous areas or areas subject to flo
ing must be performed with AS/NZS 3000-2007 as t
tries outside of Australia and New Zealand)
LL
on equipment is not responsible for the damage which
r and any other person or equipment when: -
n practices were performed.
evices were used.
ucture or the gate or door strength and rigidity was n
s were employed.
equipment.
beyond the manufacturers control.
any maintenance, qualified personnel only to carry ou
e used should there be a requirement for them.
ear of the gate whilst in operation or potentially able
formation concerning the use of the automation equi
override and maintenance procedures to the users of
NSTALLATION
/
OR DAMAGE TO P
PROPERTY
equipment.
should not be used
ed in transit.
hearing,
e into consideration
support the
any other safety
loyed when using
the gate or door.
flooding etc.
s the guidelines.
ich may be caused
as not sufficient for
out maintenance
le to be operated.
uipment as well as
of the system.