DaytonAudio CONTRACTOR Series 사용자 설명서

{카테고리_이름} DaytonAudio CONTRACTOR Series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DaytonAudio CONTRACTOR Series 2 페이지. In-wall speaker
DaytonAudio CONTRACTOR Series에 대해서도 마찬가지입니다: 사용자 설명서 (2 페이지), 사용자 설명서 (4 페이지)

페이지 인쇄

9) Troubleshooting

Should your speakers not work properly, check the following:

No sound from speakers:

• Most stereo receivers have an A/B speaker selector switch. Make certain that this switch

is in the proper position.

• Mute feature is activated.

One speaker is playing while the other is not:

• Check the balance control on the receiver. Make sure it is centered.

• Loose connection at either the receiver or the speaker. Double check connections.

• Bad speaker cable. Replace suspect speaker wire.

Receiver cuts on and off:

• This could be caused by a short circuit between the positive and negative leads. Check

the connections at the back of the receiver, and then at the speaker. Make sure that no

strands of wire from one connector are touching the other connector.

10) Caring For Your In-Wall Speakers

The two most common ways that in-wall speakers are permanently damaged:

1) Not enough power at higher volumes.

2) Too much power at higher volumes.

Contrary to conventional wisdom, far more speakers are damaged as a result of underpower-

ing, than by overpowering. When a receiver runs out of power, it still tries to reproduce the musical

signal by "clipping" the waveform. At loud volumes, this clipping introduces gross amounts of distor-

tion to the speaker, eventually destroying it. If the sound from your in-wall speakers starts to sound

distorted, turn down the volume.

Having plenty of reserve power will help your speakers reproduce dynamic contrasts and quick

transients of music much more effectively. But you do have to exercise good judgement; too much

power will also permanently damage a speaker. Again, if you hear distortion, turn the volume down.

11) Warranty Information

Dayton Audio

products are constructed by industry experts, and are thoroughly tested before

shipment. Dayton Audio

products are warranted for the period of five years. This warranty is limited

to manufacturer defects, either in materials or workmanship. Dayton Audio

consequential on inconsequential damage to any other unit or component or the cost for installation or

extraction of any component of the audio system. In the rare case of a product failure, please contact

your place of purchase or call our Customer Support Department at (937) 743-8248.

Warranty Limitations

There are no other warranties, either express or implied, which extend the foregoing, and there are no

warranties of merchantability or fitness for any particular purpose. The warranty will not cover inci-

dental or consequential damage due to defective or improper use of products. This includes but is not

limited to burnt voice coils, overheating, bent frames, holes in the cone, or broken lead wires.

This warranty gives you specific legal rights and you may also have other rights which vary from state

to state.

Non-Warranty Service: If non-warranty service is required, the product may be sent to the Company

for repair/replacement, transportation prepaid, by calling (937) 743-8248 for details, complete instruc-

tions, and service fee charges.

All manuals and user guides at all-guides.com

is not responsible for any

CSIW-08

Contractor Series

In-Wall Speaker

User's Manual

www.daytonaudio.com

Dayton Audio

, PO Box 52, Springboro, Ohio 45066-1158