Dynafold PF-370 운영 매뉴얼 - 페이지 13
{카테고리_이름} Dynafold PF-370에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynafold PF-370 16 페이지. Automated setup folding machine
페이지 인쇄tn the original setting by the factory, the lower folding plate
is
positioned.at
the starting point ("0; point), whereas the upper folding plate will
move
to
the
following position.
Area
t
-
Upper folding
plate positioned at about 2.8"
(7.11cm)
Area
ll
-
Upper plate positioned
at about
4'
(10.16cm)
Area
lll
-
Upper
plate positioned at about 4-8"
(12.19cm)
Area
IV
-
Upper
plate positioned at about
5.6'
(14.22cm)
After
choosing one
of
the Area
(l-lv),
go on
to the
Fine adjustment
under
Self-defined mode (See
Page 12)
Note: To quit
the
self-defined mode without making
fine
adjustments, press
"up" or "down" cursor
keY.
3.
Fine adjustment under Standard
mode:
Under standard mode, press "speed
+"
and
"speed
-"
simultaneously
to
enter
into
"fine
adjustment" mode. (Picture 17) Then the digital
display
will
show "nP-1". (Picture
19)
To choose
the
lower folding plate, press
the
cursor key down. The digital display
will
show
"nP-2".
Pictu
re
17
On pressing
the cursor key left, the baffle will
move toward
starting
point.
On pressing
tne
cursor key right,
the
baffle
will
move away from starting
point. Then press the SET key
to test fold 1
sheet of paper.
lf
the
position
is not right,
go on
to a further fine adjustment. (Picture
18)
When
the
adjustment
STOP
key
to
return
to
start folding.
Note.
This adjustment
will
not
automatically.
has
f
inished, press
the
the
normal mode.
Then
be
memorized
12-
Reverse
point
Picture
Pictu
re
1
9