GAI-Tronics KETS 1141 설치 및 사용자 설명서 - 페이지 14

{카테고리_이름} GAI-Tronics KETS 1141에 대한 설치 및 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GAI-Tronics KETS 1141 20 페이지. Titan illuminated crossing telephone

8.2. Fitting the legend panel.

To fit the legend panel, first ensure that a panel has been correctly printed and

cut to size according to the template above.

Remove the faceplate from the telephone by removing the 4 retaining screws.

Locate the slot behind the window, at the left hand edge when viewing from

the front. The slot is only approximately 1mm thick, and there is a retaining

guide to keep the legend panel aligned correctly.

Gently slide the legend panel into place. Undue force should not be

necessary. Note that the slot is fairly tight to the dimensions above to ensure

correct alignment.

When fully inserted, the edge of the legend panel will protrude beyond the

circuit board to the edge of the gasket, allowing a tab for ease of removal. It

must not overlap the strip of gasket, otherwise the water seal will be

compromised.

Recommended cleaning methods are outlined below:

For normal cleaning we recommend "Virosol", manufactured by Clover

products.

Carefully follow manufacturer's instructions for storage, handling and use.

The stainless steel push-button should be cleaned regularly especially if the

telephone is in a marine environment. The stainless steel may show signs of

discolouration or rust – this will not damage the button or impair its

performance but may look unsightly and can be cleaned off using normal

cleaning agents as above. In extreme cases a mild abrasive may be

necessary.

For graffiti, paint and ink we recommend the use of 3M GR1 graffiti stain

remover.

CAUTION: This is a very aggressive chemical. Pay close attention to the

manufacturer's recommendations for storage, handling and use.

KETS 1141 Titan Illuminated Crossing Telephone