GAI-Tronics PHP400 설치 및 사용자 설명서 - 페이지 11

{카테고리_이름} GAI-Tronics PHP400에 대한 설치 및 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GAI-Tronics PHP400 20 페이지. Analogue version (1090/1099 series) with ampetronic hls-dm2 induction loop amplifier 230v ac power supply
GAI-Tronics PHP400에 대해서도 마찬가지입니다: 디자인 설치 및 사용 설명서 (20 페이지), 설치 및 사용자 설명서 (20 페이지)

페이지 인쇄

Internal power connections

5.4.

The PHP400 Help Point is provided with a 12V power supply unit, required to power the

induction loop and telephone module itself.

The power input is on CON1A as shown and is connected to the PSU in the rear section

via screw terminals in a 2 way push-in connector.

Relay outputs

5.5.

The PHP400 is equipped with 2 external relay outputs, controlled by the telephone

software. As standard only relay 1 is enabled (HD9), set to activate when the telephone

is off-hook and deactivate when back on-hook. Other options are available, but must be

specified at order time. Contact GAI-Tronics for details.

Relay 2

Relay 1

The additional outputs are provided on HD9 & HD10 as shown and are isolated SELV

outputs as defined by EN 60950-1.

To comply, the installer must ensure that any connections are within SELV limits.

Relay ratings / SELV limits: 30Vdc, 42.4V peak (resistive load)

Max switching current:

Optional external inputs

5.6.

The PHP400 can be equipped with 4 external inputs, which can be used to generate

call-in events or alarm reports (using TMA). Note – these optional connections are only

available if specifically ordered. Contact GAI-Tronics for details.

The inputs are provided on HD4 as shown, and are also labelled on the circuit board.

Control inputs are for connection to voltage free contacts only. Internal pull-up resistor

source current = 33µA. These inputs form part of a TNV3 circuit and precautions must

be taken to prevent hazardous voltages being applied to these circuits.

NB these inputs are not isolated from the telephone network.

- +

PHP400 GSM Help Point.

N/C Com N/O

Common

1 2 3 4