DayTronic 3000PLUS 사용 설명서 - 페이지 10

{카테고리_이름} DayTronic 3000PLUS에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DayTronic 3000PLUS 20 페이지. Panel meter, frequency conditioner module
DayTronic 3000PLUS에 대해서도 마찬가지입니다: 사용 설명서 (20 페이지)

페이지 인쇄

ANEL

You can easily mount the 3000PLUS instrument in your

own precut panel. See Fig. 5, below, for appropriate

cutout and hole dimensions. PANEL THICKNESS

SHOULD NOT EXCEED 1/8 INCH. The mounting proce-

dure is as follows:

Remove the two front-panel screws ("A" in Fig. 4).

Remove the front panel by inserting the tip of a flat

screwdriver into the notch at the bottom of the

panel and gently prying it out of the bezel case.

Fig. 4

3000PLUS

Panel Mounting

Fig. 5

Panel Cutout Dimensions

0.180 "

0.200 "

0.775 "

1.45 "

0.156" dia.

OUNTING

Display

4.060 "

3.700 "

Edge of 3000PLUS instrument

3000PLUS

5D40 I

WITH

1. I

NTRODUCTION

Remove the four screws ("B") holding the bezel to

the instrument housing.

NOTE: YOU DO NOT NEED TO DISCONNECT THE

INTERNAL DISPLAY CABLE.

Hold the instrument housing behind the panel and

pass the bezel through the cutout (with cable

attached).

Reattach the bezel to the housing, using the same

four half-inch screws ("B"). The ribbon cable

should fold into the space between the top of the

instrument and the upper circuit board.

Snap the front panel back into the bezel case, and

reinstall the two quarter-inch front-panel screws

("A").

User's Panel with Cutout

and Mounting Holes

Cable

NSTRUCTION

ANUAL V

(see Fig. 5)

Front Bezel

Front Panel

Panel Notch

. SB.3

3KP40 - 1.6