Greatneck 80154 소유자 매뉴얼 - 페이지 13
{카테고리_이름} Greatneck 80154에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Greatneck 80154 16 페이지. 3/8" drill
페이지 인쇄CHUCK REMOVAL
To remove the chuck:
Remove the plug from the po wer
1.
source.
2.
Remove the chuck screw using a
#2
screwdriver (see Fig. 7).
NOTE: Turn screw CLOCKWISE to
remove it. This screw has a left -
handed thread.
3.
Insert the hex key into the chuck and
tighten jaws of chuck securely
(see Fig. 8). Tap the hex key sharply
with a mallet in a COUNTER -
CLOCKWISE direction. This will loosen
the chuck on the spindle. The chuck
can now be unscrewed and removed
from the spindle by hand.
RETIGHTENING LOOSE CHUCK
After installing the chuck once it has been
removed, the chuck may become loose on
the spindle and develop a wobble. Also, the
chuck screw may become loose causing
the chuck jaws to bind and prevent them
from closing. To tighten the chuck, follow
these steps:
1.
Insert hex key into chuck and tighten
chuck securely.
2.
Tap hex key sharply with a mallet in a
CLOCKWISE direction. This will
tighten the chuck on the spindle.
ASSEMBLY & OPERATION
3.
Open chuck jaws and remove the hex
key.
4.
Tighten the chuck screw using a #2
screwdriver.
NOTE: Turn screw COUNTER-
CLOCKWISE to tighten it. This screw
has a left-handed thread.
13
Fig. 7
Fig. 8