Greatneck 80154 소유자 매뉴얼 - 페이지 6
{카테고리_이름} Greatneck 80154에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Greatneck 80154 16 페이지. 3/8" drill
페이지 인쇄Make sure your extension cord is the
proper size. When using an extension
cord, be sure to use one heavy enough to
carry the current the tool will draw. An
undersized cord will cause a drop in line
voltage resulting in loss of power and
overheating. The table at right shows the
correct size to use according to cord length
and nameplate ampere rating. If in doubt,
use the next heavier gauge. The smaller
the gauge number the heavier the cord.
Be sure your extension cord is properly
wired and in good condition. Always
replace a damaged extension cord or have
it repaired by a qualified electrician before
using it. Protect your extension cord from
sharp objects, excessive heat and damp or
wet areas.
Use a separate electrical circuit for your
power tools. This circuit must not be less
than 14 gauge wire and should be
protected with either a 15A time delay fuse
or circuit breaker. Before connecting the
power tool to the power source, make sure
the switch is in the OFF position and the
power source is the same as indicated on
the nameplate. Running at lower voltage
will damage the motor.
WARNING:
!
damaged or worn extension cords
immediately.
EXTENSION CORD GUIDELINES
Repair or replace
SAVE THESE INSTRUCTIONS FOR REFERENCE
Select the appropriate extension cord
gauge and length using the chart below.
MINIMUM GAUGE (AWG) EXTENSION
CORDS (120 V use only)
Ampere rating
Not
More
more
than
than
0
6
6
10
10
12
12
16
6
Total length in feet
25'
50'
100'
18
16
16
18
16
14
16
16
14
14
12
Not
Applicable
150'
14
12
12