Automatic Technology GDO-8 Shed Master 소유자 매뉴얼 - 페이지 12
{카테고리_이름} Automatic Technology GDO-8 Shed Master에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Automatic Technology GDO-8 Shed Master 20 페이지. Weather resistant roll up door opener
Automatic Technology GDO-8 Shed Master에 대해서도 마찬가지입니다: 설치 지침 (2 페이지)
페이지 인쇄
12
GDO-8 ShedMaster
9. Troubleshooting Guide
Symptom
The opener does
not work from the
transmitter
The door does not work
from transmitter or
operate button
The door does not work
from the operate button
The manual release
handle does not work
The transmitter range
varies or is restricted
The door reverses for no
apparent reason
®
Home Owner's Manual
Possible cause
Garage door in poor condition e.g.
springs may be broken
The opener does not have power
The battery in the transmitter is flat
Transmitter does not contain
TrioCode
128 Technology
TM
The opener has been put into
"Vacation Mode"
The transmitter button is not
programmed to operate the door.
Door Code LED is flashing yet the
opener is not working.
The opener is disengaged
The control panel has been locked
out.
The security lock is engaged,
locking / disabling the manual
release cord.
Variations are normal depending
on conditions e.g. temperature or
external interference
The battery life is exhausted
Position of the transmitter in the
motor vehicle
This may occur occasionally from
environmental conditions such as
areas that are windy, dusty or have
extreme temperature changes.
If Safety beams are installed they
may be partially obstructed.
Remedy
Check the door's operation - see
monthly maintenance (Section 10.1)
Plug a device of similar voltage
(e.g. a hairdryer) into the power
point and check that it is OK
Replace the battery (Section 10.5)
Check that the transmitter has grey
buttons and the model number
on the back displays V2. Contact
dealer for support if otherwise.
Turn off "Vacation Mode"
(Section 8.2, step e)
See coding transmitter procedure
(Section 8.1 and 8.4)
Ensure the correct button on the
transmitter is being pressed.
Re-engage the opener
(Section 6.4)
Unlock the control panel
(Section 6.6)
Unlock the security lock on the
opener using the lock key.
See instructions for correct use of
transmitter (Section 4)
Refer to battery status (Fig 10.2)
Change the position (Section 4)
Put the door into manual (Section
6.1, take note of the CAUTION) and
contact your dealer.
Ensure the beam path is not
obstructed. If continues, contact
your dealer.