GAI-Tronics 293-103 매뉴얼 - 페이지 5

{카테고리_이름} GAI-Tronics 293-103에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. GAI-Tronics 293-103 20 페이지. Externally powered emergency phones

페이지 인쇄

S.M.A.R.T. E

XTERNALLY

Installation

ATTENTION

accordance with the National Electrical Code or applicable local codes.

Safety Guidelines

When installing any GAI-Tronics telephone equipment, please adhere to the following guidelines to

ensure the safety of all personnel:

•

Do not install telephone wiring during a lightning storm.

•

All telephone models must be properly connected to earth ground to protect personnel and to minimize

the effects of any electrostatic discharge (e.g., lightning). The Model 293-103AL, 294-103AL, 297-

103, and 298-103 Telephones each include a ground terminal. Please note proper grounding does not

eliminate the need for lightning protection for the telephone or the telephone system.

•

An additional UL Listed lightning arrestor may be installed on any phone or phone cable that is

exposed to a higher risk of lightning strikes. The lightning arrestor must be installed as close to the

phone as possible to maximize the protection. It must not be installed within the enclosure supplied

with the phone. Please consult our Service Center at 800-492-1212 for further information.

•

Do not install telephone jacks in wet locations unless the jack is specifically designed for wet

locations.

•

Do not touch uninsulated telephone wires or terminals unless the telephone line has been

disconnected at the network interface.

•

If an ac source is available within five feet of the telephone, the included power supply can be used.

The ac source and power supply must be mounted in a dry location, such as a GAI-Tronics stanchion.

•

If the ac source is located more than five feet from the telephone, either extend the wiring of the

included power supply, or provide a UL LISTED "Class 2" 12 volt dc regulated power supply.

Additionally, if the ac source is not located within the same structure or building, lightning/surge

protection is required.

General Installation Guidelines

GAI-Tronics S.M.A.R.T. phones are designed to operate on telephone lines as detailed in the Product

Overview section of this manual. The telephones are designed to operate with one telephone per line. If

telephones are operated in parallel or "party line configuration" you may experience sporadic phone

operation, difficulties with programming, or premature disconnection of calls. Additionally, if special

features, e.g. voice mail, call waiting, etc, are not disabled, the phone may not function.

Tamper-Resistant Hardware

All of the telephones described in this manual are vandal resistant. The front panel for each telephone in

this manual is attached to its enclosure with tamper-resistant screws. A GAI-Tronics Model 233-001

Tamper-Resistant Screwdriver (sold separately) is recommended for installing the tamper-resistant screws.

Conduit Installation Details

GAI-Tronics recommends installing telephone lines in conduit to protect against accidental damage and

vandalism. To prevent moisture from entering the enclosure, we strongly recommend the following:

•

Conduit should enter the enclosure from the bottom.

•

Sealed fittings should be installed at all cable entry points.

•

Silicone sealant or equivalent should be applied around and inside all conduit entries.

d:\standard ioms - current release\42004 instr. manuals\42004-377c.doc

08/06

ADA-C

OWERED

OMPLIANT

Installation should be performed by qualified personnel and only in

MERGENCY

HONES

PUB. 42004-377C

4 of 18

AGE