GAI-Tronics 298-103 매뉴얼 - 페이지 6

{카테고리_이름} GAI-Tronics 298-103에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. GAI-Tronics 298-103 20 페이지. Externally powered emergency phones

페이지 인쇄

S.M.A.R.T. E

XTERNALLY

Models 293-103, 293-103AL, and 294-103AL

The mounting and wiring instructions for Models 293-103, 293-103AL and 294-103AL are as follows:

1. Remove the front panel of the telephone by

removing the four tamper-resistant screws.

2. Remove the front panel of the enclosure.

Carefully place the front panel assembly in a safe

location while installing the back box.

3. Position the enclosure on the mounting surface.

The enclosure provides four 0.28-inch mounting

holes. Secure it with the four ¼-inch diameter

bolts of the appropriate length for the mounting

surface.

4. For Model 293-103 only, create an access hole

using a Greenlee-type punch that is equivalent in

size to the conduit diameter. Bottom entry is

strongly recommended. Insert a conduit fitting

in the access hole. Refer to conduit installation

details on page 4.

: Use silicone sealant or equivalent around and inside all conduit entries.

OTE

Figure 2. Model 294-103AL

: When using the GAI-Tronics Model 231-001 Pole Mounting Kit, follow the mounting

OTE

instructions provided in the kit.

d:\standard ioms - current release\42004 instr. manuals\42004-377c.doc

08/06

ADA-C

OWERED

OMPLIANT

MERGENCY

HONES

Figure 1. Model 293-103 and Model 293-103AL

5. Pull the telephone line and power supply cord

through the conduit. Connect the power supply 4-

pin connector to the P17 header jack on the

PCBA.

6. Connect the telephone line directly to TB1 (Tip

and Ring terminals) or install a modular jack in

the back of the enclosure and connect the pre-

installed modular plug to the jack.

7. Using the Setup section of this manual:

•

Make hardware configuration changes.

•

Adjust the audio levels if necessary.

•

Perform the initial programming.

8. Verify the phone is operating properly by calling

to and from another phone.

9. Complete the installation by attaching the front

panel assembly to the rear enclosure using the

four tamper-resistant screws.

PUB. 42004-377C

5 of 18

AGE