GAI-Tronics PHP400 디자인 설치 및 사용 설명서 - 페이지 3
{카테고리_이름} GAI-Tronics PHP400에 대한 디자인 설치 및 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GAI-Tronics PHP400 20 페이지. Analogue version (1090/1099 series) with ampetronic hls-dm2 induction loop amplifier 230v ac power supply
GAI-Tronics PHP400에 대해서도 마찬가지입니다: 설치 및 사용자 설명서 (20 페이지), 설치 및 사용자 설명서 (20 페이지)
페이지 인쇄
Safety and Care Information
1.
IMPORTANT:
▲
THIS PRODUCT CAN CONTAIN HAZARDOUS VOLTAGES. IT IS ESSENTIAL
THAT THE WATERPROOF SEAL IS PROPERLY MADE DURING INSTALLATION,
TO ENSURE THAT WATER CANNOT GET INTO THE ENCLOSURE. THE
INGRESS OF WATER CAN CAUSE ACCESSIBLE PARTS OF THE TELEPHONE
TO BECOME LIVE, AND THEREFORE MUST BE PREVENTED AT ALL COSTS.
Please read these instructions thoroughly before starting installation. These
▲
products must be installed by competent personnel familiar with electrical and
network installations.
Refer to safety information is section 5.2 if hazardous voltages (eg mains) are
▲
to be connected to this product.
Make sure that correctly-sized cable glands are used, and that cables are
▲
securely clamped in the clamps provided. Failure to do so could result in an
unsafe installation.
Take adequate precautions when opening the case or installing. Isolate
▲
connections elsewhere before opening.
Product Description and Features
2.
This manual describes the voice over internet protocol (VoIP) version of the GAI-Tronics
400mm circular Help Point. This product is based on the standard VoIP product range
and has been specifically configured for use on rail platforms, with features including:
Weather and vandal resistant casing
•
Large, palm-operable, vandal resistant buttons
•
Internal induction loop
•
Raised text and Braille legends
•
Wide operating temperature range
•
48Vdc powered
•
Automatic outgoing call diversion (memory list)
•
SIP compatible (RFC3261)
•
Real-time alarm reporting via email or Syslog
•
Configurable via web page, serial link or download
•
4 auxiliary inputs, 2 volt-free contact outputs
•
Models are available with different pushbutton options.
The Help Point casing is a two-part construction with electronics in both sections. The 2
sections are held together with 4 security screws though the sides, and there are
several cables between the 2 sections. Cable entry points are provided to top and
bottom of the casing. Blanking plugs are provided for unused cable entries.
400mm VoIP Help Point, 48V VoIP.
3