AirCycler g2-k 설치 및 사용 설명서 - 페이지 4

{카테고리_이름} AirCycler g2-k에 대한 설치 및 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AirCycler g2-k 11 페이지.
AirCycler g2-k에 대해서도 마찬가지입니다: 교육 매뉴얼 (20 페이지), 설치 테스트 매뉴얼 (2 페이지), 설치 테스트 매뉴얼 (2 페이지)

페이지 인쇄

DAMPER LOCATION

The fresh air damper can be located anywhere in the inlet duct. Minimize the length of the inlet duct to improve air

flow and improve system efficiency. It is recommended that the damper be as close to the return air plenum and the

AirCycler® g2 controller as possible, and the inlet duct connect to the return plenum upstream of the system filter, and

down- stream of any duct mounted sensors.

DAMPER INSTALLATION

The damper may be installed in any position. It is recommended to install it with the motor at the12 o'clock position if

mounted horizontally. Air may flow through in either direction, although it is recommended to install with the crimped

end as the outlet. Use care to avoid distorting the damper housing and provide adequate support.

CHOOSE A FRESH AIR LOCATION

ASHRAE recommends that the fresh air intake be located at least 10 ft. from any source of pollutants, such as auto

exhaust, dryer exhaust, exhaust from any fuel-burning appliances, etc. Avoid installation near odor sources such as

garbage bins or barbecue grills. A minimum of 3 ft. above ground is recommended to avoiding ingress of leaf litter,

grass clippings, etc. Do not use a crawl space, basement, or attic as a source of intake air. Always be sure to comply with

local building codes and requirements regarding fresh air inlets.

Thermostat

AirCycler®

Filter

Main Return

Duct

Motorized

Damper

Outside

Air Duct

AC DOC 8.5

REV 11/21/2014