Dynalabs DYN-IS-40 제품 설명서 - 페이지 8
{카테고리_이름} Dynalabs DYN-IS-40에 대한 제품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynalabs DYN-IS-40 13 페이지. 40 n inertial shaker
페이지 인쇄All rights reserved. Reproduction or issue to third parties in any form whatsoever is not permitted without written authority from the proprietors.
3) Operation and Installation
3.1) General
The general shaker connector configuration is given below.
The Gain Knob is a push-pull and rotational switch. The amplifier is in
External Signal Mode when the Gain Knob is pushed in and the amplifier is
in Internal Signal Mode when it is pulled out.
In order to protect the amplifier from electrical problems, it is advised to turn
the Gain Knob counter clockwise to the lowest gain position before
connecting the external signal cable or before changing operational modes.
3.1.1-) External Signal Mode:
Connect DC power source and drive signal to shaker power input and signal
input respectively. Start the external signal source. Adjust the Gain of the
amplifier by turning the Gain Knob clockwise.
8