HID EdgeReader 빠른 설치 매뉴얼 - 페이지 6

{카테고리_이름} HID EdgeReader에 대한 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HID EdgeReader 14 페이지.

페이지 인쇄

1. Troubleshooting

EdgeReader and EdgePlus Installation

2.1.2

Use

The following provides information on how to access and use the Discovery Client.

Note: The computer operating the Discovery Client must be within the same subnet (IP address range)

as the Edge devices.

1. Enable Edge devices on the network

2. Click Start > Programs > VertX Tool Box > Discovery GUI to access the Discovery Client

3. Displayed is a list of Edge devices attached to the network. If there is more than one Edge

device listed, the Edge devices can be identified using the MAC Address label on the unit

4. If unsure of an Edge devices physical location click Blink ON to start the Comm LED blinking

on the Edge device. Note the name on the button will change to Blink OFF. When verification

of the Edge device is complete, click Blink OFF

5. Click Configure Unit to open the Basic Configuration page of that Edge device

6. Go to Step 1 Configure, page 6

2.2

Virtual Port

Contact an Edge device by directly connecting the computer to the Edge device using an Ethernet

cable. By default, every Edge device is configured to respond to a fixed address: 169.254.242.121.

1. Ensure you are running a Windows 2000 or XP computer

2. Disconnect your Windows computer from its hub or network

3. Connect the Windows computer to the Edge device with an Ethernet cable

Using the Windows

5. Enter ipconfig /renew -- wait for DHCP to timeout (approximately 60 sec). The computer will

acquire a 169.254.x.x address

6. Access a web browser and enter 169.254.242.121 into the Address field. The Edge device is

now accessible through this Virtual Port

Step 3 Configure

This section describes the communications configuration that enables the Edge device to

communicate with the host software.

There are three methods of communication possible on an Edge device:

• Dynamic Host Configuration Protocol (DHCP) TCP/IP Addressing

• Static TCP/IP Addressing (see

Static TCP/IP configuration)

• Modem (see

configuration)

3.1

Edge Device Communications

The Edge device communications configuration is provided through a browser-based application called

the Configuration GUI (Graphic User Interface).

Access a web browser and enter the Edge devices IP Address into the Address field.

April 2007

Start button, click Start > Run

Configuration

Checklist, page 14 for a list of criterion needed for a modem

Checklist, page 14 for a list of criterion needed for a

Part No. 82000-901

Page 6 of 14