GReddy INFO TOUCH 기본 작동 매뉴얼 - 페이지 4
{카테고리_이름} GReddy INFO TOUCH에 대한 기본 작동 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. GReddy INFO TOUCH 6 페이지.
페이지 인쇄
11. Now you can touch the Play key to display the play-back controls while the unit
replays what was recorded.
12. Use the play-back controls to Stop, Play, Pause, Slow Back, Slow Forward, Fast
Forward or Record to record a new sampling.
• NOTE: if you select record again, what was previously saved will be erased and
overwritten with new data.
• NOTE: if the unit is turned off of disconnected the recorded sampling will be erased.
How to set up optional vehicle parameters.
1. From the Monitoring Screen, touch the screen. (anywhere except at the item name)
2. The Main MENU with [PATTERN] [ITEM] [SETTING] will appear.
3. Select [SETTING].
4. Select [VEHICLE].
5. Select [WEIGHT].
a. Look up your vehicle's gross weight listed on your door jam
b. Enter this weight using the up & down arrow buttons
c. Then touch the Back button to confirm.
6. Select [ENGINE SIZE].
a. Look up your engine's cc listed on your door jam
b. Enter this cc size using the up & down arrow buttons
c. Then touch the Back button to confirm.
7. Select [BODY IMAGE].
a. Select the closest description from the list.
b. Then touch the Back button to confirm.
8. Select [CORRECTION%].
a. This is use to adjust the Power estimator reading. It can correct up to -50%
to + 50%.
b. Use the up and down arrow keys to adjust. If you reading is low, increase
the correction to a + value, if it reads high use a – value, until it is correct.
c. Then touch the Back button to confirm.
How to use the Power estimator.
1. To use this feature you must first complete "How to set up optional vehicle
parameters" above.
2. From the Monitoring Screen, Touch the indicated Item name.
3. Select [POWER].
4. Then when you accelerate the vehicle it will compare internal parameters like the
vehicle weight to the internal accelerometer to display an estimated hp reading.
How to access the DTC Diagnostic Trouble Codes.
1. From the Monitoring Screen, touch the screen. (anywhere except at the item name)
2. The Main MENU with [PATTERN] [ITEM] [SETTING] will appear.
3. Select [SETTING].
4. Select [DTC].
4