GReddy Turbo Kit 설치 매뉴얼 - 페이지 16

{카테고리_이름} GReddy Turbo Kit에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. GReddy Turbo Kit 18 페이지. 96-98 nissan 240sx s14 (ka24de) td06-20g 8cm2
GReddy Turbo Kit에 대해서도 마찬가지입니다: 설치 매뉴얼 (18 페이지), 설치 매뉴얼 (13 페이지)

페이지 인쇄

3-15 Starting the Engine

(1) Refill the engine oil to factory spec.

(2) Check all the hoses and wires connection, then reconnect the negative side of the

battery.

(3) Turn the ignition to "ON" position 2-3 times to get fuel pressure. Then, check the

injectors and the fuel rail for any fuel leaks.

* Repair any fuel leaks before starting the engine. Starting the engine with a

fuel leak can cause fire in the engine compartment and can be very

dangerous.

(4) Remove the ECM fuse and crank the engine to get oil pressure to the turbo. (Until

the oil light on the dash turns off) Check for any oil leaks, then reinstall the fuse and

start the engine.

(5) While idling, check for any oil, coolant, or air leeks.

(6) After inspection, reinstall the under cover and other stock parts that was removed.

(7) On the initial run, be sure to have a boost gauge to check the turbo-actuator setting.

This turbo kit is preset to boost between 0.6kg/cm

It is very important that you monitor the boost pressure, and make sure not to over

boost. Over boosting can cause engine damage.

• It is very important that you monitor the boost pressure, and make sure not to

over boost. Over boosting can cause engine damage.

• GReddy Performance Products, Inc. is not responsible for any engine damage

caused by over boosting (increased boost), modification to the kit, and/or

misuse of the product. NO WARRANTY is offered.

•

Due to lack of control over proper installation and use of this product,

NO WARRANTY is offered for this kit.

This completes the Turbo Kit installation.

Important!

to 0.6kg/cm