GReddy Turbo Kit Emanage Ultimate 설치 매뉴얼 - 페이지 11
{카테고리_이름} GReddy Turbo Kit Emanage Ultimate에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. GReddy Turbo Kit Emanage Ultimate 18 페이지. 2003 mazda rx-8 (13b-msp) t618z 10cm2 (actuator type)
페이지 인쇄
5. Connect the oil pressure line that was installed
in the step 3-2 to the turbocharger. Install the
turbocharger to the manifold using the provided
gasket and hardware.
6. Reinstall the engine mount bracket and rubber,
then remove the SST tool.
7. Install the suction pipe S-3 to the turbo inlet
using the provided gasket and hardware.
8. Replace the oil drain plug with the provided oil
return fitting and copper washer.
9. Install the oil return pipe to the turbo charger.
Wrap the thermo cloth to the 16
connect the oil return pipe to the oil pan.
(Parts Used #27, 32, 39, 50, 63)
10. Install the compression pipe C-1 to the turbo
out let using the provided gasket and
hardware.
11. Re install the actuator back on to the
turbocharger. Reinstall the e-clip back to the
swing valve.
(Parts Used #46, 66)
(Parts Used #7, 44, 65)
(Parts Used #28, 29)
hose and
(Parts Used #8, 45, 65)