Dynalink RTA1320 빠른 설정 매뉴얼 - 페이지 6

{카테고리_이름} Dynalink RTA1320에 대한 빠른 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynalink RTA1320 7 페이지. Adsl2+ modem router
Dynalink RTA1320에 대해서도 마찬가지입니다: 사양 (3 페이지)

페이지 인쇄

Troubleshooting

Q1. Cannot see the Connect to Internet page from my browser?

If previously the computer had a dialup modem, check browser setting. For example in

Internet Explorer, go to Tools–Internet options–Connections, and select Never dial a connection.

Also check LAN Settings that the option Use a Proxy Server is not selected.

1. Check that the modem's "Ethernet" light is on. Check that the "Ethernet" cable is ﬁrmly plugged in.

2. Perform a PING test. In Windows XP or 2000, click "Start" then "Run" . Type "Command" then click

OK. Type ping 192.168.1.1 then press "Enter" . The response should resemble:

Pinging 192.168.1.1 with 32 bytes of data:

Reply from 192.168.1.1: bytes=32 time=4ms TTL=30

If there is a similar response, the router is communicating with your computer correctly and the

problem lies elsewhere. If the result is Request timed out, there may be a network problem. Check

that the "Ethernet" cable is ﬁrmly plugged in.

3. Disable any personal ﬁrewall or virus checker temporarily.

4. If you are using Internet Explorer, go to "Tools" on the browser menu and select "Internet options"

then "Connections" and select "Never dial a connection" . Reset the security level of all 4 icons to

default. (You can revert back to your settings after conﬁguring the router) Check LAN settings to

ensure that "Use Proxy Server" is not selected.

5. If the router is connected to a network hub, try connecting the router directly to the computer in a

standalone setup to eliminate any possible problem associated with the hub.

6. Check that your Computer is set to obtain its IP address dynamically (automatically).

•

Go to "Start" > "Run" > type "ncpa.cpl" (without quotes) and press enter.

Right click Local Area Connection > Properties > Internet Protocol > Properties > Select

•

"Obtain IP address automatically" and 'Obtain DNS servers automatically" > Select OK > OK