Dynalink RTA210 빠른 설정 매뉴얼 - 페이지 12

{카테고리_이름} Dynalink RTA210에 대한 빠른 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynalink RTA210 15 페이지. Dynalink adsl router quick setup guide
Dynalink RTA210에 대해서도 마찬가지입니다: 빠른 설정 매뉴얼 (14 페이지)

페이지 인쇄

ping 192.168.1.1 then press Enter. The response should be:

Pinging 192.168.1.1 with 32 bytes of data:

Reply from 192.168.1.1: bytes=32 time=4ms TTL=30

If you see a similar response, router is communicating with the network

correctly and the problem lies elsewhere. If the result is Request timed out

or similar failures, there is a TCP/IP networking problem. Check the LAN cable

type is correct (as in step 1 above) and firmly plugged in. To check a computer's

network settings see Step 2 (Section 2 - Configuring Router).

Disable any firewall or virus checking software temporarily. If you are using

Internet Explorer, go to Tools–Internet options-Security. Reset security level

of all 4 icons to default. You can revert to your customised settings after

configuring the router.

If previously you were using a dialup modem, check browser setting. For

example in Internet Explorer, go to Tools–Internet options–Connections, and

select Never dial a connection. Also check LAN Settings that the option Use

a Proxy Server is not selected.

If the router is connected to a network hub, try connecting the router directly

to the computer in a stand-alone setup to eliminate any possible hub problems.

If the LAN is already DHCP enabled, you should assign an IP address 192.168.1.x

(x is between 2 and 254) to a host computer for initial configuration of the

router.

Q2. Cannot connect to Internet or cannot browse

Check router's DSL light is on. Normally it takes less than one minute to

establish a link with the telephone exchange. The link will establish as long

as there is signal. If the DSL light does not come on the router is not seeing

any signal. Check that:

• ADSL service has been enabled.

• Router is connected to the correct jackpoint.

• Router is connected directly to jackpoint, not after a filter or other device.

Check if router is on line. Follow the last paragraph of Step 5 (Section 2 -

Installing Router). If NAT IP shows 0.0.0.0, you are not on line. Make sure the

correct user name and password are entered. See Step 4 (Section 2 -

Configuring Router). The username and password are provided by your ISP.

Check the configuration of computer and router. If you still cannot browse,