Dynalink RTA770 빠른 설정 매뉴얼 - 페이지 8

{카테고리_이름} Dynalink RTA770에 대한 빠른 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynalink RTA770 16 페이지. Adsl router/modem

ADSL Router Quick Set-up Guide

Configuration for PPPoE service

Follow this procedure ONLY if your ISP specifies the service as PPPoE. Caution

- do not set your router to PPPoE mode if your ADSL service is PPPoA. It will not

connect. Reset to factory default will restore router to PPPoA mode.

From the Quick Start menu click on Quick Setup to configure for PPPoE.

1. Untick the Auto Scan Internet Connection box. VPI and VCI shall be set to 8

and 35 respectively. Click Next for the next page.

2. Select PPP over Ethernet (PPPoE). Encapsulation shall be LLC/SNAP as

illustrated below. Go to the next page, change nothing and then Next.

3. You can enter your Internet account User Name & Password now. If you leave

the space as blank, you will be asked to do it later. Go Next.

4. Do not change the network configuration unless you are an advanced user

having your own preferences. Go Next.

5. A summary of the configuration is displayed. Check carefully that the setting

is VPI/VCI = 8/35, Connection Type is PPPoE LLC/SNAP. Then click Finish to

confirm the changes. The router will restart itself automatically to activate

the new setting.

6. Now follow Step 2 of Section 5 – Getting On-line. The screen will show the

changes made: pppoe_8_35 has replaced the default pppoa_8_35.