Celestron 22059 빠른 설정 매뉴얼 - 페이지 2

{카테고리_이름} Celestron 22059에 대한 빠른 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Celestron 22059 20 페이지.

Tighten the threaded end of the counterweight bar into the

declination axis of the equatorial mount.

The other cable attaches to the R.A. axis gear shaft.

Loosen the set screw on the focuser. Remove the plastic cap

covering the end of the visual back.

Slide the finderscope bracket into the dovetail slot on the

telescope tube near the focuser. The large window on the

finder should be facing the front of the telescope. Secure

the bracket by tightening the setscrew on the dovetail slot.

WARNING: NEVER ATTEMPT TO VIEW THE SUN THROUGH ANY TELESCOPE WITHOUT PROPER FILTERING!

2 | ENGLISH

Remove safety screw from the end of the counterweight bar.

Slide the counterweights half way up the bar and tighten the

locking screw to secure in place. Replace safety screw.

Place the telescope tube on the equatorial mount so that the

tube is facing forward as pictured above.

Insert the diagonal into the visual back and tighten the

set screw.

There is a small clear plastic tab inserted between the

battery and the contact. This was included to prevent the

battery from discharging during shipment. Pull this out to

allow your battery to work. For longer battery life be sure to

turn off finderscope when not in use.

Slide the chrome end of the slow motion control cable onto

declination axis gear shaft.

Center dovetail in the mount and tighten fastening screw.

For added security tighten the angled lock down screw next

to the fastening screw.

Insert the chrome barrel of the 20mm eyepiece into the

diagonal and tighten the set screw.

Remove the lens cap from the front of the telescope. To

observe, look through the eyepiece as shown above. Focus

the image by turning the knob on the back of the telescope.