Dynalink QWLL100 빠른 설정 매뉴얼 - 페이지 4

{카테고리_이름} Dynalink QWLL100에 대한 빠른 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynalink QWLL100 8 페이지. Wlan usb adaptor

WLAN USB Adaptor Quick Set-up Guide

To avoid confusion, use only one of the two available utilities

to configure your wireless adaptor. To disable the Windows

XP built in utility, click open the Network Connection icon on the system tray.

Select Advanced and untick the Use Windows to configure... box as illustrated.

Click OK to finish. Now follow section 3.2.

If you wish to use the Windows XP built in wireless utility instead of the utility

supplied by the manufacturer, go directly to section 3.3.

3.2

USING THE MANUFACTURER'S WIRELESS LAN CONFIGURATION UTILITY

After completing the installation as described in section 2, you

should see a Wireless Adapter Status icon on the lower right

hand corner of your Windows desktop.

Alternatively, go to Control Panel and open this icon:

Either option will open the Wireless LAN Configuration Utility.

3.2.1

CONNECTING TO A WIRELESS ACCESS POINT (INFRASTRUCTURE MODE)

Select the Configuration tab.

In Mode, select Infrastructure.

In SSID, enter the SSID. All

wireless adaptors should use the

same SSID as the access point.

Click Apply.

Your adaptor will automatically

tune into the channel number of

the access point.

In the Status page, the wireless link

quality indicators are displayed. The

MAC address of the access point

your adaptor is associated with is

displayed under State.

If the wireless network has security

features enabled, configuration is

not complete at this stage. Please

proceed to section 4 for setting up

wireless privacy.