HID VertX EVO V1000 설치 매뉴얼 - 페이지 10

{카테고리_이름} HID VertX EVO V1000에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HID VertX EVO V1000 19 페이지.

VertX EVO V1000 Installation Guide

2.2

Virtual Port

Contact a VertX controller by directly connecting the computer to the controller using an Ethernet cable. By default, every

controller is configured to respond to a fixed address: 169.254.242.121.

Ensure you are running a Windows 2000 or XP computer

Disconnect your Windows computer from its hub or network

Connect the Windows computer to the controller with an Ethernet cable

Using the Windows™ Start button, click Start > Run

Enter ipconfig /renew -- wait for DHCP to timeout (approximately 60 sec). The computer will acquire a

169.254.x.x address

Access a web browser and enter 169.254.242.121 into the Address field. The controller is now accessible

through this Virtual Port

Step 3

Configure

This section describes the communications configuration that enables the controller to communicate with the host

software.

There are two methods of communication possible on a V1000 controller:



Dynamic Host Configuration Protocol (DHCP) TCP/IP Addressing



Static TCP/IP Addressing (see Configuration Checklist, page 15 for a list of criteria needed for a Static TCP/IP

configuration)

Enter only the configuration that relates to your sites specific installation.

3.1

VertX Communications

The VertX communications configuration is provided through a browser-based application called the Configuration GUI

(Graphic User Interface).

3.1.1

Configuration GUI Login

The Login screen for that controller displays.

In the User name field, enter admin (leaving the Password field empty). Click OK.

3.1.2

Basic Network Setup

Select the Connection Selection radio button to establish Network connection.

Default network information loads. Before making changes, review the default network information.

Note: Most configurations will not require accessing the Advanced Setup screen.

3.1.2.1

Static Network

If using a Static TCP/IP network, proceed with changes using the information collected on the

page 15.

3.1.2.2

DHCP Network

If using a DHCP TCP/IP network, this information is configured automatically.

3.1.3

Host Communication Setup

Enter the Host Name, and the Here I Am Interval collected on the

July 2011

Configuration

Checklist, page 15.

Checklist,

Page 10 of 19