Celestron 31043 빠른 설정 매뉴얼
{카테고리_이름} Celestron 31043에 대한 빠른 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Celestron 31043 2 페이지. Celestron astromaster 114az: install guide
Celestron 31043에 대해서도 마찬가지입니다: 빠른 설정 매뉴얼 (10 페이지)
페이지 인쇄1
Your AstroMaster 114AZ includes: optical tube w/
built-on StarPointer finderscope, pre-assembled
tripod with center leg brace and attached
altazimuth mount, two eyepieces, accessory tray,
lens cloth, battery, owner's manual, and The Sky™
CD Software.
4
All three legs should be the same length to provide
a level platform for the telescope.
7
Here is how the fully assembled tripod and mount
should appear.
Quick set-up guide for:
Model #31043 – AstroMaster 114AZ
2
To set up the tripod, spread the legs outward until
they are fully extended. Extend each of the three
tripod legs down 6-12".
5
To attach the accessory tray, line up notches and
turn clockwise until tray tabs lock into place with
the tripod brackets.
8
dovetail
mount
fastening
screws
Next slide telescope tube into the mount. Be sure to
back out fastening screws to allow enough
clearance for the dovetail.
www.celestron.com
Questions or Problems with Set-up?
CONTACT: Celestron Technical Support:
310.803.5955
Quick Set-up Guide
3
Use the three tightening screws located at the
bottom of each leg to secure the extended legs
in place.
6
Properly assembled, the accessory tray should
appear as pictured above.
9
Center dovetail in the mount and tighten fastening
screw. For added security tighten the angled lock
down screw next to the fastening screw.