Celestron 52280 사용 설명서 - 페이지 7

{카테고리_이름} Celestron 52280에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Celestron 52280 17 페이지. Celestron spotting scope instruction manual 80ed

Built-in T-Adapter

Threads

Attaching a Camera

To attach a camera to your 80ED spotter:

1. Remove all visual accessories.

2. Thread the proper T-Ring onto the built-in T-Adapter threads at the end of the 1.25" eyepiece

adapter.

3. Mount your camera body onto the T-Ring the same as you would any other lens.

The focusing mechanism is the same photographically and visually. However, due to the high

magnification, the micro prism focuser in your camera may "black out." If this is the case, you will

have to use the ground glass portion of your focusing screen, which itself may be dark. For the best

results, take your time. Look at your subject carefully to make sure that you have the sharpest

possible focus. To achieve a very sharp focus, consider using a focusing magnifier. These devices are

readily available from your local camera store.

If you can not get a sharp focus, check to see if your subject is closer than the near focus distance

listed in the "Technical Specification" section.

Storing Your Spotting Scope

To minimize the need to clean your spotting scope, replace all lens covers after use. The spotting

scope can be left on a tripod for display purposes or returned to its shipping carton. Since the rear cell

of your spotting scope is not sealed, the eyepiece or protective cover MUST be placed over the

opening in the rear cell when not in use. This will prevent contaminants from entering the optical

system.

2" Focuser

Barrel

Figure 4

1 ¼" Eyepiece

Adapter

Focuser Tension

Screw

Focuser Knob