HID TECHNICAL SOLUTIONS 1126 사용자 설명서 - 페이지 8

{카테고리_이름} HID TECHNICAL SOLUTIONS 1126에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. HID TECHNICAL SOLUTIONS 1126 14 페이지. Desktop uhf rfid reader with usb

www.tsl.com

INSTALLING THE SOFTWARE

Demonstration software is provided for use with Windows XP, Vista and 7. The following instructions assume one

of these operating systems is being used. Drivers are available for other operating systems but no demonstration

software is provided. Contact Technology Solutions Support ([email protected]) for further information.

Plug in the reader to a USB port capable of supplying 500mA. This will usually need to be a port on a computer

rather than a hub, unless the hub is powered.

The reader will be discovered and the driver software should be automatically located and installed (the computer

may need to connect to the internet to obtain the driver.)

The reader will be given a Virtual Com port (VCP) as part of the driver installation. If you have several devices

already connected to your computer (including Bluetooth devices) you may need to use Device Manager to find

out which VCP has been given to the reader.

Navigate to Device Manager from 'Start>Control Panel>Device Manager' (or one of the many alternative ways).

Expand the section 'Ports (COM & LPT)' to see a list of the available ports. This will look similar, but not identical

to the one below:

Unplug the reader and one of the USB Serial Port entries will disappear. Plug it back in and the entry will reappear.

This is the VCP for the Desktop Reader.

To demonstrate the capabilities of the UHF RFID Desktop reader install and use the UHF ASCII Demo FX as

directed on the CD.

1126 Desktop UHF Reader User Guide V1.31